This is an Uno R3 microcontroller starter learning kit with some common electronic components and sensors are included. The kit contains more than 120 components and electronic modules, these components can be divided into about 30 species. We have carefully prepared a guidebook, and supporting experimental code routine for you to learn. The guidebook includes 26 experiments, and the code is divided into two versions(C and Python). Through the learning, you will get a better understanding of Uno R3, and will be able to make fascinating works based on Uno Microcontroller. If you want to learn the basics of electronics and Linux programming, this kit is a wonderful choice for you. In the process of learning this kit, you will get perfect technical support. By learning this kit, you will be fully aware of the wonderful world of electronics and the fun of DIY.
1x EB UNO R3 Board, 1X Rotary Encoder Module, 1x DC Motor, 1x L9110 motor driver, 1x LCD1602, 1x I2C Interface Module, 1X Ultrasonic Distance Sensor, 1x 7-Segment Display, 1x NE555 Chip, 1x Passive Buzzer, 1x Active buzzer, 2x Photoresistance, 2X Thermistor, 2x Tilt Switch, 2x Switch, 1x RGB LED, 4x Red LED, 4x Green LED, 4x Yellow LED, 4x Blue LED, 16x Resistor(220O), 10x Resistor(1 kO), 10x Resistor(10 kO), 5x Capacitor(104), 2x Capacitor(10uF), 4x Button(large), 8x Button(small), 1x Button cap(red), 1x Button cap(white), 2x Button cap(blue), 2x NPN Transistor(8050), 2x PNP Transistor(8550), 2x Potentiometer(10KO), 1x 9V Battery Holder 1x Breadboard, 1x USB Cable, 40x Male to Male Jumper Wires, 20x Male to Female Jumper Wires, 1x 4-Pin Wires, 1x 5-Pin Wires, 1x Band Resistor Card